RIDGID Auto-Clean K-30 Manual do Operador

Auto-Clean™Drain Cleaning MachineModel No. K-30WARNING!Read this Operator’s Manualcarefully before using thistool. Failure to understandand follow the

89. Evaluate the work area and determine if any barriersare needed to keep bystanders away from the draincleaner and work area. Bystanders can distrac

9Grasp the AUTOFEED with one hand and hold it sothat the end of the AUTOFEED is within 6" (15 cm) ofthe drain opening. See Figure 11.The guide ho

10Auto-Clean™ Drain Cleaning Machinewind up and control the cable. As you feel the cablewind up or if the cable end stops turning, immediately re-leas

11Auto-Clean™ Drain Cleaning Machine2. Loosen the three screws surrounding the outer drumhousing. (The screws do not need to be completelyremoved). Re

12Auto-Clean™ Drain Cleaning Machine11. Replace the drum cover by lining up the holes overthe screws. Then fasten screws.12. Reattach the guide hose a

13Auto-Clean™ Drain Cleaning MachineCable kinking or breaking.Cable stops rotating whilefoot switch is depressed.Restarts when foot switchis re-depres

Table of ContentsRecording Form for Machine Serial Number ...

Auto-Clean™Drain Cleaning MachineModel No. K-30Drain CleanerAuto-Clean™ Drain CleanerRecord Serial Number below and retain product serial number which

2Auto-Clean™ Drain Cleaning MachineGeneral Power Tool SafetyWarnings*WARNINGRead all safety warnings and instructions. Failure to followthe warnings a

3Personal Safety• Stay alert, watch what you are doing and use com-mon sense when operating a power tool. Do notuse a tool while you are tired or unde

4Auto-Clean™ Drain Cleaning Machinechine is standing in water. Operating machine whilein water increases the risk of electrical shock.• Only use drain

Figure 1 – Auto-Clean Drain CleanerMachine AssemblyWARNINGTo reduce the risk of serious injury during use, fol-low these procedures for proper assembl

6shock, do not use the machine until the cord hasbeen replaced by a qualified repair person.3. Clean any oil, grease or dirt from all equipment han-dl

7. Position the drain cleaning machine so it sits squarelyand firmly on the rubber feet provided. The end of theAUTOFEED must be within 6" (15 cm