RIDGID DP15501 Manual do Operador descarregar pdf (Página 20)

OPERATION

TO DRILL TO A SPECIFIC DEPTH

See Figure 19.

To drill a blind hole (not all the way through) to a given

depth, proceed as follows.

n Mark the depth of the hole on the workpiece.

n Loosen the depth scale lock.

n With the switch OFF (O), bring the drill bit down until the

tip of lip of the bit are even with the mark.

n Turn the depth scale counterclockwise until it stops

moving.

n Tighten the depth scale lock.

n The drill bit will stop at this depth until the depth scale is

readjusted.

TO DRILL USING THE DEPTH SCALE

See Figure 20.

n With the power off (O), loosen the depth scale lock.

n Place workpiece on table. Adjust table until the tip of the

drill bit is just a little above the top of the workpiece, turn

the depth scale counterclockwise to zero.

n Turn the depth scale clockwise until the depth scale

indicator points to the desired drilling depth on the

depth scale.

n Tighten the depth scale lock.

n The chuck or drill will now be stopped after traveling

downward the distance selected on the depth scale.

TO LOCK CHUCK AT DESIRED DEPTH

See Figure 20.

n With the switch off (O), loosen the depth scale lock.

n Turn the feed handles until the chuck is at the desired

depth. Hold feed handles at this position.

n Turn the depth scale clockwise until it stops.

n Tighten the depth scale lock.

n The chuck will now be held at this depth when the feed

handles are released.

Fig. 19

Fig. 20

DEPTH SCALE

LOCK

MARK

DEPTH SCALE

LOCK

DEPTH

SCALE

FEED

HANDLES

DEPTH

SCALE

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Comentários a estes Manuais

Sem comentários

RIDGID DP15501 Manual do Operador Página 20

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas elétricas RIDGID DP15501