Ridgid R1000 Manual do Utilizador

OPERATOR’S MANUAL 115 mm (4-1/2 pulg.) ANGLE GRINDERR1000SAVE THIS MANUAL FOR FUTURE REFERENCEYour angle grinder has been engineered and manufactured

1011 WARNING:The angle grinder should never be connected to a power supply when you are assembling parts, mak-ing adjustments, cleaning, performin

1011ASSEMBLYFig. 3aFig. 3b• To install optional flap disc (sold separately): Place the flap disc over the spindle. Thread the clamp nut on the spindl

1213ADJUSTMENTS WARNING:The angle grinder should never be connected to a power supply when you are assembling parts, mak-ing adjustments, cleaning

1213OPERATION WARNING:Always wear safety goggles or safety glasses with side shields when operating this tool. Failure to do so could result in du

1415OPERATIONn Move the grinder continuously, at a steady, consistent pace. CAUTION:If the grinder is held in one spot too long, it

1415MAINTENANCE WARNING:When servicing use only identical Ridgid replace-ment parts. Use of any other parts may create a hazard or cause p

1617NOTES

1617NOTES

1819NOTES

1819This product is manufactured by One World Technologies, Inc., under a trademark license from Ridgid, Inc. All warranty communications sh

23TABLE OF CONTENTSn Introduction...

20983000-2333-04OPERATOR’S MANUAL 115 mm (4-1/2 pulg.) ANGLE GRINDERR1000Customer Service InformationFor parts or service, contact your nearest Ridgid

23GENERAL SAFETY RULES WARNING:Read and understand all instructions. Failure to fol-low all instructions listed below, may result in electric

45SPECIFIC SAFETY RULESn Always use proper guard with grinding wheel. A guard protects operator from broken wheel fragments.n Accessories mu

45 SYMBOLSThe purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and the explanations with them, deserve

67SPECIFICATIONSGrinding Wheel Capacity...

67UNPACKINGInstructionsYour angle grinder has been shipped completely assem-bled.n Carefully remove the tool and accessories from the box.n M

89Before using the angle grinder, familiarize yourself with all operating features and safety requirements. However, do not let familiarity with the t

89FEATURESFig. 1CLAMPNUTDISCFLANGECLAMPSCREWGUARDWRENCHSPINDLELOCK BUTTONGRINDING WHEELSIDE HANDLESWITCH