RIDGID NaviTrack 10 Manual do Operador Página 17

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 20
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 16
Ridge Tool Company ● Elyria, Ohio ● U.S.A www.navitrack.com 15
NaviTrack Brick Line Transmitter
Trouble Shooting Guide
PROBLEM REMEDY
LEDs appear com-
pletely dark, or
completely light when
unit is ON.
Try Powering the unit OFF and then back ON.
Allow the unit to cool if it has been exposed to excessive heat from sunlight.
Receiver will not pick
up the line trans-
mitter’s signal.
Check that the correct frequency has been selected on both units. (See manual for the
specific receiver.) Higher or lower frequencies may be tried.
Check to make sure that the receiver and the line transmitter are in the same mode.
Make sure that the proper functions are activated on the receiver. e.g. activating the line
trace function for line tracing.(See manual for the receiver.)
Adjust power upward if possible.
Ensure grounding is adequate.
If using inductive mode, check for core damage using the test on page 12.
Unit will not turn ON.
Check orientation of batteries.
Check that the batteries are fresh or charged.
Check to see that the battery contacts are OK.
93 kHz signal not
received
Check that receiver is set to the actual 93kHz freguency of 93,696 Hz. Some receivers
use a different frequency for 93 kHz (93,622.9). Update locator software.
Vista de página 16
1 2 ... 12 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários