RIDGID R4090 Manual do Operador descarregar pdf (Página 13)

13 — English

Fig. 7

RIGHT OUTER

TUBE

LEFT

UPPER

TUBE

SPACER

LOCK

NUT

RIGHT UPPER

TUBE

INNER LEG

ASSEMBLY

CENTER

BRACE

AXLE

LOCK

NUT

FLAT WASHER,

MEDIUM

STOP

WHEEL

LEFT

OUTER TUBE

HEX HEAD

BOLT

LOWER

BRACE

CARRIAGE

BOLT

ASSEMBLY

FLAT WASHER,

LARGE

ASSEMBLING THE WSUV™ WET SAW

UTILITY VEHICLE / LEG STAND

See Figure 7.

Many of the WSUV™ / leg stand parts are movable. All

hardware must be tightened securely but not so tight that

the utility vehicle / leg stand won’t open and close. For easier

assembly, match letter to letter.

Place a curved spacer over the end of the lower brace (F).

Insert a hex head bolt and small ﬂat washer at the bottom

of the right outer tube (G) and into the lower brace (F).

Tighten securely. Repeat for the other side.

Place a carriage bolt through the center hole in the outer

tubes (G) then place a spacer on the bolt.

Slide the bolt/spacer into the inner leg assembly (G) and

secure in place using a lock nut. Do not overtighten.

Repeat for the other side.

Place the center brace on top of the inner leg assembly

(curve side up) with the stop pin under the pedal assembly

latch.

NOTE: The stop pins rest on top of inner leg assembly.

Insert a carriage bolt through the top hole of the inner leg

assembly then slide a spacer on the bolt. Repeat for the

other side.

Slide the center brace onto the bolt (F) and secure in

place using a lock nut. Repeat for the other side.

With the curve handle turned downward, secure the up-

per tubes (E and H on the right side, and A and D on the

left side) to the leg stand using carriage bolts, spacers,

and lock nuts. The tube with the diverter valve attached

should be placed on the left side of the leg stand.

 Locate the lock nut and two ﬂat washers.

 Slide the ﬂat washer, wheel, and ﬂat washer onto the

axle through the hole in the center of the wheel. Secure

in place using lock nut.

 Repeat with the second wheel.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 32 33

Comentários a estes Manuais

Sem comentários

RIDGID R4090 Manual do Operador Página 13

Comentários a estes Manuais

Manuais e produtos relacionados com Serras circulares RIDGID R4090