RIDGID SS1650 1 Manual do Operador descarregar pdf (Página 8)

ASSEMBLY

TS2400 TABLE SAW

See Figure 8

n Height: Shortest

n Width Left/Right: Widest

n Width Front/Back: Widest

TP1300 THICKNESS PLANER

See Figure 9

n Height: Tallest

n Width Left/Right: Middle

n Width Front/Back: Widest

Fig. 8

Fig. 9

PLANNING FOR NON-RIDGID TOOLS

Other benchtop power tools may be mounted on this

legset. However, first make sure:

n The benchtop power tool does not weigh more than 300

pounds and is evenly distributed on the particle board

table top.

n The benchtop power tool is securely fastened to the

particle board top.

n The combined leg stand and attached benchtop power

tool are stable and will not tip.

If your tool is similar to one of the above, use that setup

configuration.

ATTACHING LEVELING FEET

See Figure 10

n Locate the following parts and hardware.

Hex Nuts, 3/8-16 (8)

Leveling Feet (4)

Lower Legs, (Stamped “D”) (4)

n Thread hex nut to within 1/4 in. of the bottom of each of

the four leveling feet.

n Install leveling feet through holes in lower legs as shown.

Finger tighten nuts.

n Final adjustment and tightening of the leveling feet

will be needed once you have completed the entire

assembly process.

Fig. 10

ASSEMBLING UPPER AND LOWER LEGS

See Figures 11-12.

n Locate the following parts and hardware.

Carriage Bolts, M8 x 1.25-16 (8)

Hex Flanged Nuts, M8 x 1.25 (8)

Lower Legs, (with leveling feet attached) (4)

Upper Legs, (Stamped “B”) (4)

NOTE: Hardware not pictured full size.

n Position the lower leg inside the upper leg for the desired

height setting

LEVELING

FOOT

1 2 3 4 5 6 7 8 9 10 11 12 13

Comentários a estes Manuais

Sem comentários

RIDGID SS1650 1 Manual do Operador Página 8

Comentários a estes Manuais

Manuais e produtos relacionados com Serras circulares RIDGID SS1650 1