RIDGID NaviTrack 10 Manual do Operador Página 14

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 24
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 13
SeekTech ST-510 Line Transmitter
Inductive Clamp Method
Figure 16: Inductive Clamp (Optional)
1. Plug the inductive clamp into the 1/4" phone
jack above the battery cover. Plug must be
mono or, if stereo, connected between tip
and base. The coil cords are disabled when
the clamp is connected.
2. Clamp the jaws of the Inductive Clamp
around a section of the pipe or cable to be
traced.
3. Power the transmitter on and proceed as in
the Direct Connect method. Be sure the
receiver and the transmitter are set to the
same frequency.
Inductive Mode
The ST-510 can be used without a direct connection
to a pipe or cable. In Inductive Mode, the ST-510
generates a field which induces a current into a
conductor such as a pipe running directly beneath it.
1. Be sure that the transmitter is positioned
correctly over the line.
Figure 17: Orientation to the Conductor
(Inductive Mode)
2. Push the inductive mode (upper right) button
to induce a signal onto the line. The Inductive
Mode message will appear on the screen.
SeekTech
TM
)
)
)
)
)
)
SeekTech
TM
)
)
)
)
)
)
Inductive
Key
Orientation
Mark
Figure 18: Inductive Mode Key
3. Lower frequencies couple poorly inductively.
When using Inductive Mode, use higher
frequencies in order to get a good signal at the
receiver.
4. Note that the line into which current is induced
must be grounded in both directions for a
signal to be induced away from the transmitter.
5. The transmitter in inductive mode will generate
a field through the air around it as well as into
the ground under it. If the receiver is within
about 20-30 feet of the transmitter it will
Vista de página 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comentários a estes Manuais

Sem comentários