RIDGID NaviTrack 10 Manual do Operador descarregar pdf (Página 17)

SeekTech

ST-510 Line Transmitter

Other Manufacturers Menu

This menu allows you to use the ST-510 to transmit

on different manufacturer’s frequencies. This is

convenient if you are using a locator/receiver other

than a SeekTech (the default setting). Simply choose

the manufacturer of the intended receiver and

frequencies for that system will be loaded and

available. See the Manufacturer’s Frequencies table

on page

20.

)

Figure 27: Manufacturers Menu Selection

This selection brings up the list of manufacturers.

)

Figure 28: List of Manufacturers (First Screen)

When using a receiver frequency set other than

SeekTech’s, select the frequency according to the

relative position of the other manufacturer’s

frequency on their frequency list (see table on page

20). For example, the low frequency key would

corre

spond to their lowest frequency; the highest

frequency key to their highest. If the manufacturer

has more than 4 frequencies, the highest frequency

key will switch to the next highest frequency. The

selection will move up one frequency for each press;

after the highest available frequency is reached the

selection will cycle to the lowest frequency in that set.











Low

Med Low

Med High

High

Figure 29: Frequency Buttons

Adjusting the LCD Screen Contrast

LCD contrast is set at the factory and should not

normally require adjustment. Optimal contrast is set

when the background remains white, while the black

pixels are set to be as dark as possible.

Note: The LCD can be adjusted to completely white

or completely black, which will affect readability.

LCD contrast may change with extremes in

temperature. When the screen is exposed to high

heat from direct sunlight it may darken. It is

recommended that the screen be shaded if it is to

be exposed to excessive sunlight. Use the shoulder

strap to cover the screen if needed.

If the display appears too dark or too light when it is

on, it is likely that the LCD contrast has become

misadjusted. First try powering the unit OFF and then

back ON. If the problem persists adjust the LCD

contrast darker or lighter as needed.

To adjust the LCD Contrast:

1. Press and hold down the select key:

2. Simultaneously press the up arrow key to

lighten the display or press the down arrow

key to darken the display.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários

RIDGID NaviTrack 10 Manual do Operador Página 17

Comentários a estes Manuais