RIDGID NaviTrack 10 Manual do Operador descarregar pdf (Página 14)

12 www.navitrack.com Ridge Tool Company  Elyria, Ohio  U.S.A

way to confirm that you are locating the

induced signal in a line and not the signal

directly from the transmitter through the air (air

coupling).

Note: If you have been using the NaviTrack

transmitter in inductive mode, be certain to switch

inductive mode off if you are going to use the unit in

direct connect mode. Air coupling can create very

confusing signals if you inadvertently have the unit

set to inductive mode but are trying to use it in

direct connect mode.

Features

Variable Power Output

The power output can be adjusted to apply more

current to a line. Higher currents are easier to trace

as they create more signal for the receiver to track

but they also use the battery power faster.

1. Turn the unit on and press one of the

frequency buttons to select a frequency to use.

The LED representing that frequency will shine

steadily.

Figure 13: Selecting a 1 kHz Frequency

2. Press the same frequency key quickly and

release. One of five levels of output will be

shown by a flashing LED. The lowest is the

farthest to the left. Note the bar graph above

the LEDs for reference.

Figure 14: Flashing LED Indicates Medium Power

Level

3. The original frequency LED will then come

back on constantly. (See the FCC limitation in

the specifications section for information on

frequencies and power output.)

Figure 15: Steady 1kHz LED

Note: When the LED is constant it is showing the

frequency selected. When it is flashing it

represents the power level. If the frequency

selected corresponds to the same level of output,

the same LED will flash and then return to a

steady light.

Selecting another LED while the LED is steady will

change the frequency To change the power output

select another level while the LED is flashing. The

new power level

will flash five times, and the LED will

then appear steadily over the chosen frequency

. The

beep frequency will rise accordingly if you have

increased the power. If you check the power output

again by pressing the currrent frequency rapidly, the

new power-selection will be indicated by the LED

over it flashing rapidly.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários

RIDGID NaviTrack 10 Manual do Operador Página 14

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas elétricas RIDGID NaviTrack 10