RIDGID R4120 Manual do Operador descarregar pdf (Página 24)

OPERATION

Fig. 27

CROSS CUT

WORK CLAMP

Fig. 28

MITER CUT

TO MITER CUT / CROSS CUT

See Figures 27 - 28.

A cross cut is made by cutting across the grain of the

workpiece. A straight cross cut is made with the miter table

set at the 0° position. Miter cross cuts are made with the

miter table set at some angle other than zero.

 Pull out the lock pin and lift saw arm to its full height.

 Lift the miter lock lever to unlock. Rotate the miter table

until the pointer aligns with the desired angle on the miter

scale.

NOTE: You can quickly locate 0°, 15°, 22.5°, 31.6°, and

45° left or right by spinning the miter thumbwheel up.

The lock plate will seat itself in one of the positive stop

notches, located in the miter table base.

 Push the miter lock lever down to lock the miter table.

 Place the workpiece ﬂat on the miter table with one edge

securely against the fence. If the board is warped, place

the convex side against the fence. If the concave edge

of a board is placed against the fence, the board could

collapse on the blade at the end of the cut, jamming the

blade. See Figures 36 - 37.

 When cutting long pieces of lumber or molding, support

the opposite end of the stock with a roller stand or with

a work surface level with the saw table. See Figure 31.

 Align cutting line on the workpiece with the edge of saw

blade.

 Grasp the stock ﬁrmly with one hand and secure it against

the fence. Use the work clamp or a C-clamp to secure

the workpiece when possible.

 Before turning on the saw, perform a dry run of the cut-

ting operation to make sure that no problems will occur

when the cut is made.

 Grasp the saw handle ﬁrmly. Depress the switch lock

with thumb then squeeze the switch trigger. Allow several

seconds for the blade to reach maximum speed.

 Slowly lower the blade into and through the workpiece.

 Release the switch trigger and allow the saw blade to

stop rotating before raising the blade out of workpiece

and removing the workpiece from the miter table.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Comentários a estes Manuais

Sem comentários

RIDGID R4120 Manual do Operador Página 24

Comentários a estes Manuais

Manuais e produtos relacionados com Serras circulares RIDGID R4120