RIDGID TS3650 Manual do Operador descarregar pdf (Página 27)

ASSEMBLY

TO INSTALL THE ANTI-KICKBACK PAWLS AND

BLADE GUARD

See Figures 37 - 39.

WARNING:

Replace dull or damaged anti-kickback pawls.

Dull or damaged pawls may not stop a kickback

increasing the risk of serious personal injury.

NOTE: Anti-kickback pawls should only be installed for

through cuts.

 Unplug the saw.

 Raise the saw blade.

 Place spreader/riving knife in “up” position.

To install anti-kickback pawls:

 Press and hold the button on the right side of the anti-

kickback pawls.

 Align the slot in the pawls over the rear slot in the spreader/

riving knife.

 Push the pawl handle down snapping them into place

and release the button.

NOTE: Pull on the handle to make sure pawls are

securely locked.

To install blade guard:

 With the front of the blade guard raised and the guard lever

unlocked, lower the back of the guard into the middle slot

of the spreader/riving knife. Push the front of the guard

down until it is parallel to the table.

 Lock the guard in place by pushing the guard lever down.

NOTE: Blade alignment with the spreader can be adjusted

for different blade widths. Refer to: To Check and Align the

Spreader/Riving Knife and Saw Blade. Check the blade guard

assembly for clearances and free movement.

blaDe

GuarD

sPreaDer/

rIVING KNIfe

GuarD

leVer

INcOrrect

cOrrect

Fig. 38

Fig. 39

aNtI-KIcKbacK

Pawls

Pawl

haNDle

buttON

Fig. 37

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 53 54

Comentários a estes Manuais

Sem comentários

RIDGID TS3650 Manual do Operador Página 27

Comentários a estes Manuais

Manuais e produtos relacionados com Serras circulares RIDGID TS3650