RIDGID R4511 Manual do Operador descarregar pdf (Página 6)

Using the tail hook

The Shark Guard has a horizontal hooked slot at the rear and a vertical slot further

forward. These slots are the mounting slots for this guard. The hooked slots get hooked

on the rear studs of the clamp. There is a safety hook that slips down over the rear

stud to keep the guard from coming off when not intended. You can see in this image

that the guard can be left in the upward position by hooking only the rear slots and

resting the guard on the front stud and brass bushings. This ability is beneficial when

measuring between the fence and blade with a steel rule. The front slots just slip

down over the front studs with care taken to use the smaller bushing diameters. With

this done and your tail hook swung down into place, your blade guard is installed.

1 2 3 4 5 6 7 8 9

Sem comentários

RIDGID R4511 Manual do Operador Página 6