RIDGID TS3612 Manual do Operador descarregar pdf (Página 3)

Fig. 2

ASSEMBLY

Fig. 1

WARNING:

Do not connect to power supply until assembly

is complete. Failure to comply could result in

accidental starting and possible serious personal

injury.

WARNING:

Never stand directly in line with the blade or allow

hands to come closer than 3 in. to the blade. Do

not reach over or across the blade. Failure to heed

this warning can result in serious personal injury.

WARNING:

The zero clearance insert must be even with the

table surface. Inserts too high or low can let the

workpiece “snag” or catch on uneven edges.

Workpiece could twist and kick back resulting in

injury.

REMOVING THE EXISTING INSERT AND

INSTALLING ZERO CLEARANCE INSERT

See Figures 1 - 2.

n Unplug the saw.

n Lower the blade completely then remove the blade guard

assembly.

n �Loosen the flat head screw and remove the insert by lifting

the front end of the insert and pulling it toward the front

of the saw.

n Place the zero clearance insert in the table slot and push

toward the rear of the saw, making sure to engage the

spring clip.

n Position the zero clearance insert until the key slot drops

over the flat head screw.

n The insert should be flush with the table top.

Adjust the

four set screws as needed.

NOTE: If necessary, adjust the side positioning set screw

found on the edge of the zero clearance insert to eliminate

side play. Tighten the flat head screw. Do not tighten the

screw to the point where it deflects the insert.

INSERT

FLAT

HEAD SCREW

STRAIGHT EDGE

SET SCREWS

HEX KEY

1 2 3 4 5 6

Comentários a estes Manuais

Sem comentários

RIDGID TS3612 Manual do Operador Página 3

Comentários a estes Manuais

Manuais e produtos relacionados com Serras circulares RIDGID TS3612